VESSEL electric screwdriver VE-5000R Lever type Output torque: 0.6-2.5N・m

[Features]
●The grip is easy to hold with a gel pad that absorbs vibrations, making it less tiring. (ergonomic design)
●Maintenance-free, no need to replace carbon brushes.
●Prevents erroneous adjustment with a tamper-proof sleeve.
● There is no connection connector on the main unit side, and the power cord is integrated (2.5m).
●The speed of screw tightening work has been increased by 20%. (Compared with VE-5000 and VE6000.)
● Uses a slotless brushless motor.
● Tightening accuracy, efficiency, and maintainability are improved.

[Use]
●For control of simultaneous use of multiple models on the assembly line, interlocking with peripheral devices, etc.

【specification】
- Output torque (N m): 0.6 to 2.5
- Total length (mm): 290
No-load rotation speed (min [[-1 power]]) strong: 1200
No-load rotation speed (min [[-1 power]]): 1200
- Compatible screw (mm) small screw: M3.0 to 4.0
- Bit opposite side (mm): 6.35
- Compatible screw (mm) tapping screw: 2.6 to 3.5
Power consumption (W): 120
-Power cord length (m): 2.5

[Specification 2]
● Lever type
Rated input: AC100V 50/60Hz 120W
-Attached bits: A14 +2 x 65...2
-Torque adjustment ring: 16 steps x 8 scales

[Material/Finish]
● PC + elastomer

[Set contents/accessories]
Suspension ring: 1 piece
Tamper-proof sleeve: 1 piece
● Set screw (M3 × 3): 2 pieces
●Hex wrench (H1.5): 1 piece
- 3P2P conversion adapter: 1 piece
●Instruction manual

【Note】
● Read the instruction manual carefully and check that the wiring is correct before turning on the power.
● Do not use anything other than a PLC (photocoupler input) for the device connected to the signal output line.
●Do not connect the + side of the power supply directly to the signal output line.
●There will be no current limiting resistor, and the photocoupler will be damaged.
●Do not drive relays, motors, lamps, etc. directly connected to the signal output line.