N IS Luster zinc spray 400ML

[Features]
●By using zinc flake powder and bright aluminum powder, the bright finish is the closest to the plating color.
●Since it uses epoxy resin, it adheres well to the base material, and can be overcoated, increasing workability.
●It is a 1-liquid type that does not drip when painting and has a short drying time.

[Use]
●Weld marks, cut surfaces, drilling of galvanized steel, zinc sagging, scratches, non-plated areas, etc.
●Alternative to zinc plating for large structures that do not fit in a plating bath or for thin objects that are subject to heat distortion.
● Life-prolonging repair coating of galvanized steel towers, bridges, electrical equipment, etc. that have begun to rust due to aging.
●For long-term rust prevention of steel materials.

【specification】
Color: Bright silver
-Capacity (ml): 400
-Operating temperature range (°C): temperature 5°C or higher, humidity 85% or lower

[Specification 2]
Zinc content in dry coating film: 82%
●Drying time: dry to the touch 20 minutes (20℃)
- Coating area: 1.2 square meters (recommended film thickness 80 μm)
Heat-resistant temperature (after application and drying): 180 ° C
●Operating temperature range: Temperature 5℃ or higher (Humidity 85% or lower)

[Material/Finish]
Main ingredients: Zinc dust (flake powder), aluminum powder, epoxy resin, solvent, additives

[Set contents/accessories]
-

【Note】
●To prevent clogging, be sure to shake the container up and down 20 times or more before use.
●If there is any left over after use, turn the container upside down for about 2 seconds and put the cap back on for re-use.
●Please refer to the Safety Data Sheet (SDS) for detailed information.