VESSEL Dendora Ball 220USB-1 with USB cable

[Features]
An electric ball grip driver equipped with a lithium-ion battery and motor.
Early tightening can be done with an electric motor, and final tightening can be done like a manual screwdriver.
Equipped with a slide switch that allows forward and reverse rotation to be operated with light force.
Kosoku rotation improves work efficiency.
ALUMIS chuck that can be used with double-headed and single-headed bits.
Charging can be done easily with a USB port.
It has a built-in high-precision LED light that can be used even in dark environments.
In addition, it is a delay specification that shines for 5 seconds after use.

[Use]
For electrical/equipment work, board assembly, equipment/equipment maintenance, automobile/motorcycle maintenance, DIY, etc.

【specification】
No-load rotation speed (min [[-1st power]]): 280
Maximum tightening torque (N m): 2 (electric)
Shaft length (mm): 100
Edge: [[+]]2
Total length (mm): 140
Handle diameter (mm): 45
Shaft length (mm): 100
Handle diameter (mm): 45
Total length (mm): 140
Edge: [[+]]2

[Specification 2]
Endurance Torque (Manual): 10N･m
Applicable bit: Width across flats 6.35 mm (single-head/double-head bit)
Battery capacity: Li-Ion 3.6V 800mAh
Charging time: about 60 minutes
Charging times: about 500 times
Continuous use time: about 40 minutes (when no load)
Screw tightening times: about 200 times (M4 x 20mm)
Sleeve: 6.35 mm across flats, ALUMIS chuck
Charging method: USB charging (Micro USB-typeB)

[Material/Finish]
Body: ABS + Elastomer, Bit: Special Alloy Steel

[Set contents/accessories]
Bit: [[+]] 2 (100 mm) x 1
USB charging cable (1m)

【caution】
Please be sure to read the instruction manual.
Be careful of short circuits and electric shocks when working with electricity.
Overloading can damage screws and cause injury.
At home, please be careful with your children.