Teraoka universal type ball mill stand (inverter specification) BKFD-203

[Features]
●By adopting the inverter control system, the rotation of the roller can be digitally controlled steplessly, so accurate rotation speed can be obtained from low speed to Kosoku rotation.
●The inverter UNIT has a built-in thermal protector, so there is no need to worry about motor burnout.
● Pots can be hung on both the upper and lower shelves, so you can work efficiently.
●Multiple pots with the same outer diameter can be hung by adjusting the interval between the rotating shafts.
● Pots that can be used are φ100 to φ318 mm.
● If multiple pots are hung and rotated, the pots may collide and be damaged.
●To prevent this, use a spacer (sold separately).

[Use]
- External dimensions: about (W) 800 x (D) 600 x (H) 880 (mm)

【specification】
●Type: 2 steps
●Number of revolutions (rpm): 0 to 150
- Width (mm): 961
- Depth (mm): 633
- Height (mm): 915
Power supply (V): three-phase 200
-Roller material: urethane rubber
●Model: BKFD-203
●Type: 2 steps

[Specification 2]
●Safety functions: electronic thermal, ground fault overcurrent when power is turned on, overload limit, external trip, memory error, overvoltage control during deceleration, momentary power failure protection, emergency shutdown, etc.
-Power cord length: about 3m

[Material/Finish]
-Mounting: Painted finish on iron

[Set contents/accessories]
-

【Note】
● A separate packing fee of 12,000 yen is required.
● Pots and spacers are sold separately.